VehicleVerdict

2010 Peterbilt 382 problems

Verdict · NHTSA data

Limited data — recalls on file

NHTSA has just 0 complaints on file for the 2010 Peterbilt 382 — too few to judge reliability from owner reports alone — but 2 recall campaigns apply to this year, so any used example should have its VIN checked for completed recall work.

0

NHTSA complaints

2

Recalls

1

Investigations

0

Crash-involved

0

Fires reported

0

Injuries

0

Deaths

NCAP overall

Does the 2010 Peterbilt 382 have recalls?

2 NHTSA recall campaigns on file. Recall repairs are free at franchised dealers.

15V309000EngineMay 26, 2015 · 4,823 units

Defect

PACCAR Incorporated (PACCAR) is recalling certain model year 2010-2016 Kenworth T440, T800, and W900 trucks manufactured August 31, 2009, to April 20, 2015, and 2008-2015 Peterbilt 320, 337, 348, 365, 382, and 384 trucks manufactured July 27, 2007, to April 28, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

Consequence

If engine oil comes into contact with a hot surface, there is an increased risk of a fire.

Remedy

Cummins will notify owners on behalf of PACCAR, and Cummins service centers will administer the repairs which include securing the ends of the 90-degree elbow and reprogramming the electronic control module (ECM) with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Kenworth customer service at 1-425-828-5000, Peterbilt customer service at 1-940-591-4000 or Cummins Inc. at 1-800-343-7357. PACCAR's number for this recall is 15KWH and 515-G.

15V132000OtherMarch 6, 2015 · 213,230 units

Defect

PACCAR Incorporated (PACCAR) is recalling certain model year 2006-2016 Peterbilt 587, 579, 567, 389, 388, 387, 385, 382, 379, 378, 367, 365 and 357 trucks manufactured July 25, 2005, to February 26, 2016. The affected vehicles may be equipped with Tire and Rim Certification Labels that list a tire pressure below the actual correct amount. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 120, "Tire selection and rims and motor home/recreation vehicle trailer load carrying capacity information for motor vehicles with a GVWR of more than 4,536 kilograms (10,000 pounds)."

Consequence

If the tires are underinflated due to the incorrect inflation pressure listed on the label, the truck may not be able to carry the maximum gross vehicle weight rating (GVWR) load listed without experiencing tire failure which would increase the risk of a crash.

Remedy

Peterbilt will notify owners and mail them a corrected Tire and Rim certification label, free of charge. The recall began on June 19, 2015. Owners may contact Peterbilt customer service at 1-940-591-4000. PACCAR's number for this recall is 215-D.

2010 Peterbilt 382 — common questions

Is the 2010 Peterbilt 382 reliable?

The record is thin — 0 NHTSA complaints — so owner-report data can't strongly confirm reliability either way, though 2 recalls should be verified as completed.

Does the 2010 Peterbilt 382 have recalls?

Yes — NHTSA lists 2 recall campaigns affecting the 2010 Peterbilt 382. Recall repairs are free at franchised dealers; check the VIN at nhtsa.gov/recalls to confirm the work was done.

Is the 2010 Peterbilt 382 under NHTSA investigation?

NHTSA opened one investigation into this model year; all are now closed.

Related

Based on NHTSA ODI data through June 2026. Complaints are consumer-reported and unverified. Updated July 5, 2026.

Compiled by Sharon Ben-Moshe, Founder.